How to change your broken or burned out projector lamp ?

Changing a broken or burned out projector lamp with its casing

Replacing a projector lamp is a simple operation that does not cause any damage to your projector.

All video projection devices facilitate this operation, most often a single flap appears prominently behind the projector. With a screwdriver you can open the valve, remove the broken lamp, and then install the new lamp projector. This operation of replacing a projector lamp last about a minute.

Install a broken or burned out projector bulb without casing

Only the bulb is sold, not the casing. It is therefore necessary to recover the broken or burned lamp cartridge, by removing the bulb. Once removed, insert the new bulb in the cartridge, then the two elements together in the projector.

Justprojectorlamps.co.uk offers projectors bulbs for which the replacement is easy. If the replacement is complex, we do not propose it. Replacing a bulb should be quickly and easily, without damaging the bulb or casing.

This operation, even if it is simple, requires little skill and care during the installation of the projector bulb. If you return a bulb and we see that it has been damaged during the assembly process, we will replace it. Customers utilizing this offer must have sufficient dexterity to do this technique.

Make sure the screws / nuts terminals are not too tight, otherwise these can crack the ceramic insulation damage the lamp and break your projector However, if the terminals are not tight enough, they can cause excessive load on the ballast, and ultimately the failure of the latter.

Make sure the bulb is housed in the cartridge. The tendency is to stop at the first sign of resistance. Continue to apply pressure to the base of the bulb until the bulb is fixed in the cartridge.